TAMIYA TA-02 Main Drive Shaft with Joint - JR-TA200-LB by Jazrider  [JR-TA200-LB]

Replacement Overview for TA-02 Aluminum Shaft

This aluminum main drive shaft with joint is a scale RC replacement part made for the TAMIYA TA-02 chassis. The piece pairs a machined aluminum shaft with an integrated joint to transmit rotational loads from the gearbox output to drivetrain linkages, and arrives in a light blue finish to complement visual upgrades on hobby models.

Installation is straightforward for experienced model builders: remove the original plastic shaft, inspect gearbox bearings and seals for wear, then slide the aluminum shaft into position and secure the joint following the chassis manual. The item is supplied as an RC-scale accessory only and must be installed using the existing TA-02 chassis hardware.

For tuning and maintenance the shaft serves two practical goals: it replaces a wear-prone stock component to restore correct drivetrain geometry, and it offers a harder material surface that can increase perceived durability under normal hobby use. Check set screws, splines, and nearby bearings after initial runs to confirm fit and alignment.