Tamiya TA01/TA02 Aluminum Rear Shock Tower (Blue) JAZRIDER JR-TA105-DB  [JR-TA105-DB]

Aluminum rear shock tower engineered for TA01/TA02

This aluminum rear shock tower from JAZRIDER is an aftermarket replacement designed for use with Tamiya TA01 and TA02 chassis layouts. As a rear suspension mounting plate it provides a rigid anchor for shock absorbers and links, helping to keep shock geometry consistent under load and during tuning changes.

Build and tuning role: the tower serves as the upper mounting point for rear shocks and can influence rear roll characteristics and damping feel when different mounting holes or shock angles are used. Swap-in aluminum towers are chosen by drivers who want a firmer mounting point and repeatable setup adjustments compared to original plastic parts.

Compatibility and fit: this item targets Tamiya TA01 and TA02 platforms, matching the chassis mounting pattern used by those models. Because it is an aftermarket aluminium part, verify hole alignment with your chassis before final assembly and use the original shock hardware and hex screws where applicable.

Installation notes: install with the chassis supported and shocks removed or loosened to avoid preload on the mounting points, tighten fasteners to a controlled torque to prevent stripping, and check alignment after installation. Routine inspection for thread engagement and tightness is recommended after initial runs.