Tamiya TA-01 Front Suspension Arms (Red) - JR-TA110-RD by Jazrider  [JR-TA110-RD]

Red anodized aluminum front arms for TA-01

These aluminum front suspension arms (JR-TA110-RD) are an aftermarket replacement crafted for the Tamiya TA-01 chassis. Supplied in a red anodized finish, the components are made as direct-fit RC-scale replacements to swap in for the stock front arms on compatible TA-01 models without chassis alteration.

Fit the arms using the TA-01 chassis' original mounting points and standard hardware where possible. During installation inspect ball studs and linkage clearances, confirm equal left/right fitment, and check steering travel before the first run. No special vehicle-specific tools are required beyond the basic hobby tools normally used for 1/10 scale models.

Switching from molded plastic to aluminum alters front-end flex and can change steering feedback and transient behavior. Use these arms as a tuning component: make small adjustments to servo endpoints, tie-rod lengths, and roll center settings over test laps to dial in the preferred balance for your on-road sessions.