TAMIYA T3-01 Rear Axle Upgrade ST3037 for DANCING RIDER by GPM  [ST3037]

Replacement hardened rear axle for T3-01

This hardened steel rear axle is an RC-scale replacement part made for the TAMIYA T3-01 DANCING RIDER chassis and is supplied as one set. It is intended for hobby use on model cars and functions as a direct rear-end component for repair or stepwise tuning.

As a tuning piece the axle increases rear assembly stiffness and provides a tougher contact surface compared with softer stock parts. It is helpful when refining rear traction behaviour or when swapping a worn axle during routine upkeep.

Fitting requires removal of the existing rear axle assembly, checking fit with your current bearings and hubs, and fastening the axle with the vehicle's standard hardware. After installation confirm free rotation and correct wheel alignment before running the model.

For ongoing service inspect axle surfaces for wear and corrosion, keep mating bearings clean, and recheck fastener torque after initial test runs to maintain consistent performance.