TAMIYA T3-01 DANCING RIDER Rear Sway Arm Aluminum Adjustable Link T3332R by GPM  [T3332R]

Rear sway arm summary

This aftermarket rear sway arm is an RC-scale replacement and tuning part designed for the TAMIYA T3-01 DANCING RIDER platform, model T3332R. It replaces the stock rear sway arm to give a stiffer, lighter link and to alter chassis roll response through adjustable ball end positions.

The arm is machined from aluminum 6061 T6 and includes stainless steel flat head screws, washers, copper bead and white silicone rings used to control play around the screw shafts. Ball connectors at both ends are adjustable; moving them outward increases the vehicle's lean angle and shifts roll transfer between the axles, allowing finer cornering balance without changing suspension geometry.

Installation uses the supplied hardware and follows the standard T3-01 linkage attachment points, retaining the common ball stud interfaces. The silicone rings act as shims to reduce axial play while preserving small movement needed for a natural suspension response.

Fit this arm when you want a durable, lightweight rear sway link to refine lean angle and roll behaviour on the T3-01 DANCING RIDER; adjust the ball ends incrementally and test lap-by-lap to dial handling to preference.