TAMIYA T3-01 DANCING RIDER Rear anti-rattle screw kit 2.5x14 T3050R/SM by GPM  [T3050R/SM]

Rear wheel anti-rattle kit

This stainless steel rear wheel flat-head screw and washer set replaces the original TAMIYA T3-01 DANCING RIDER rear wheel fasteners to reduce play and improve rear stability. The kit increases bearing surface at the wheel hole and uses corrosion-resistant stainless hardware for longer life.

Contents include two stainless steel flat-head screws sized 2.5x14 and two stainless steel flanged washers. The larger-diameter flange spreads load across the wheel hole more effectively than the stock washers, closing small gaps and keeping the wheel steadier under braking and cornering loads.

Installation is simple: remove the factory rear wheel screws, fit the flanged washers against the wheel, then secure with the 2.5x14 flat-head screws. Tighten until the wheel seats firmly but do not over-torque to avoid deforming plastic hubs. Intended for hobby RC use with both original wheels and compatible optional wheels.