TAMIYA T3-01 9mm Rear Wheel Hex Upgrade - T3010/9MM by GPM  [T3010/9MM]

Aluminum 9mm wheel hex for T3-01 hubs

This aluminum rear wheel hex is an RC-scale spare for the TAMIYA T3-01 Dancing Rider, supplied as 1pair. It provides the 9mm hex interface used to secure wheels to the T3-01 rear hubs and offers a stronger metal alternative to the stock plastic hexes.

Installation notes: ensure the 9mm hex seats fully into the wheel hub and that the wheel bore aligns correctly before final tightening. After fitting, check for any axial play and correct wheel seating to prevent uneven tyre wear. Use this item as a direct replacement or a modest tuning upgrade to increase hub stiffness for on-road use.

Care and longevity: aluminum resists deformation better than common plastics, helping keep wheel alignment consistent during spirited runs. Inspect the hexes periodically for corrosion or wear if exposed to damp conditions and replace them if you find burrs or any visible distortion.