TAMIYA Scania R620 Receiver Bottom Plate TRU205SC by GPM  [TRU205SC]

Receiver Base Plate Details

This alloy receiver bottom plate is an RC-scale replacement part for the TAMIYA Scania R620 tractor truck. It provides a firmer mounting surface for the receiver tray to reduce flex and maintain long-term fitment in scale truck projects.

Fitment and role: made to sit on the stock receiver tray mounting points of the Scania R620 chassis, the plate gives a solid base for the receiver and wiring runs, helping to stabilise radio gear during towing and low-speed manoeuvres. It is supplied as a direct aftermarket upgrade that does not require chassis modification.

Installation notes: the plate fits using the original screw locations and stock hardware where possible, allowing a straightforward swap of the factory plastic tray with minimal disassembly. Inspect existing thread condition, use thread locker on set screws if needed, and confirm the receiver and antenna routing clear any nearby bosses before final tightening.

Tuning and maintenance: this chassis-level hop-up targets mounting rigidity rather than weight saving. When adjusting suspension or payload layout, keep receiver position and cable routing consistent to preserve radio reliability. Check screw torque and inspect for contact with moving components on a regular schedule.