TAMIYA Scania R620 Mid-Chassis Reinforcement Alloy 3pcs TRU009SC by GPM  [TRU009SC]

Midframe reinforcement for Scania R620

This RC-scale mid chassis mount is made for TAMIYA Scania R620 tractor truck kits and is supplied as a 3pcs alloy set TRU009SC. It acts as a reinforcement and tuning accessory to increase structural rigidity around the centre of the chassis and to give stable mounting points for suspension and drivetrain linkages.

The component replaces the common plastic or softer bracket to reduce flex under load and to provide repeatable alignment during setup. Installation is intended to use the existing chassis holes and hardware where possible to avoid extra drilling; confirm fitment before final tightening and apply thread lock to steel fasteners if the chassis manual recommends it.

In tuning terms this mount is conservative and mechanical: limiting mid-chassis deformation helps preserve suspension geometry and drivetrain alignment when you change ride height, adjust suspension travel, or shift weight distribution for handling improvements.

Fit this mount where you need stronger centre-chassis support for scale tractor truck builds, and double-check clearances around the gearbox and suspension before completing the install.