Tamiya MF01X Front/Rear CVD Hard Steel Shafts MF1230C by GPM  [MF1230C]

Replacement Hard Steel CVD Shafts for MF01X

This aftermarket drive shaft set fits Tamiya MF01X chassis and is listed as MF1230C. It provides a front and rear constant velocity drive shaft solution in hard steel intended for scale RC use on MF01X-based cars. The set is meant to replace worn or damaged stock plastic shafts when a metal drivetrain upgrade is preferred.

The shafts are a direct-fit option for MF01X layouts that use CVD-style drive joints. The hard steel construction offers a wear-resistant alternative to softer materials and is suitable when correcting drivetrain slop, replacing snapped shafts, or preparing a model for heavier running conditions.

Installation notes: confirm MF01X compatibility before fitting, check retaining hardware and bearings for wear, and verify correct spline engagement and pin retention during assembly. You may need to reset suspension droop and toe after replacing driveline components to restore handling balance.

Use this set when replacing MF01X CVD shafts to preserve driveline function and to standardize on metal replacement parts during routine maintenance or setup changes.