This aluminium front suspension arm is an aftermarket replacement manufactured by GPM for use on Tamiya MF01X platforms and M06-compatible layouts. Supplied as a 1pr set, the metal arm replaces the stock plastic unit to give improved dimensional stability and longer service life compared with standard plastic parts.
The component is produced to match the MF01X / M06 mounting pattern and is intended as a direct-fit upgrade using the chassis original attachment points. In most installs existing hardware can be reused, but confirm thread engagement and fastener type before assembly and perform a short systems check after fitting. Verify wheel toe and camber and run a brief test before full use.
As part of a tuning progression, aluminium arms change front-end stiffness and load response. This arm suits hobbyists moving to metal components; review spring rate, damper tuning and steering geometry after installation to retain the desired chassis balance.
Sold as a 1pr metal replacement, this GPM MF055 arm gives a direct-fit aluminium option for MF01X and M06 front suspension setups intended for regular tuning and maintenance.
Copyright © 2008-2026 rcjaz.ca All rights reserved
