Tamiya M08 Chassis Stiffener S Graphite for 210 - Factory Pro O-TCPM01S  [FP-O-TCPM01S]

Price:
CAD$19.47
Brand:
Factory Pro
Model:
FP-O-TCPM01S
Condition:
Brand New
Write a review

M08 centre stiffener overview

This graphite centre stiffener is an aftermarket RC part for the Tamiya M08 chassis, sized S to suit the 210 fitment. It reduces torsional flex by adding a rigid plate in the factory-designated area, altering twist without changing suspension pickup geometry.

Fitting uses the M08s existing mounting points, locating into the appointed stiffener bay and fastening with the original hardware; in typical builds no additional drilling or permanent modification is needed. Always check clearance with your 210-spec components before final tightening.

From a setup perspective the stiffener changes how load transfers between left and right under cornering. Strengthening the centre usually sharpens turn-in and evens out roll transition, which helps when tuning for tighter lap times or matching chassis stiffness to spring and damper choices.

Which Tamiya M08 layouts accept this part?

This stiffener is specified for the Tamiya M08 platform in the S size for the 210 configuration; confirm your chassis mounting pattern and component clearances before ordering.

Will I need extra bolts or spacers to install it?

It is designed to reuse the stock mounting points and standard hex hardware on the M08. Some custom setups may require common washers or short spacers, but specialised fasteners are generally not needed.

What handling changes should I expect on track?

Adding graphite to the centre reduces chassis twist, often producing crisper steering and a steadier mid-corner transition. Use suspension and tyre adjustments alongside the stiffener to retain a balanced setup.

Copyright © 2008-2026 rcjaz.ca All rights reserved