Tamiya M07 Rear Suspension Arm M07-06 - Direct replacement part by 3Racing  [M07-06]

Aftermarket rear arm for M07 touring cars

This rear suspension arm is an aftermarket replacement designed for the Tamiya M07 chassis. It restores or adjusts rear suspension geometry on 1/10-scale electric touring cars and is aimed at hobbyists performing routine maintenance, repairs, or setup tweaks.

The geometry-focused design prioritizes correct fit and straightforward installation over cosmetic change. It replaces the stock rear arm assembly and returns mounting points and pivot locations to the nominal positions expected in typical M07 setups. Fit this part when an arm shows wear, has a crack, or when you need a spare during trackside repairs.

Installation notes: remove the wheel and hub to access the arm, support the chassis while releasing rear pivot hardware, transfer any required ball studs or bushings from the original arm, and torque fasteners to the vehicle manufacturer's recommended values. No chassis modification is required for standard M07 configurations.

Tuning role: swapping rear suspension arms can alter rear track consistency and the way the rear end responds under cornering and throttle. Install matched arms on both sides and recheck alignment and suspension droop after fitting to preserve predictable handling between runs.