TAMIYA M07 Front and Rear Stabilizer Bars M07-16 by 3Racing  [M07-16]

Stabilizer Bars for TAMIYA M07 Chassis

This is an RC stabilizer kit designed for the TAMIYA M07 chassis, sold as part M07-16. The pair of bars tunes front and rear anti-roll behaviour to affect body roll and cornering balance without changing major suspension geometry.

The components act as tuning links between the suspension and chassis roll response, allowing drivers to alter understeer or oversteer by adjusting front-to-rear roll stiffness. Fitment matches M07-series mounting points so no major adaptors are required on a standard TAMIYA M07 layout.

Installation is straightforward for those used to on-road setup: remove the body, access the roll bar endpoints, fit or swap the stabilizer elements into the existing mounts, then check steering clearance and suspension travel. Verify there is no binding and tighten fasteners; small changes to bar orientation or link length will shift effective roll rate.

For practical tuning start from a neutral baseline and change one axle at a time, noting effects on turn-in, mid-corner grip, and exit stability. Use short runs to evaluate each change rather than stacking multiple adjustments.