TAMIYA M06 Rear Hub Carrier Upgrade, Anodized Red - M06-13001-RD by Jazrider [M06-13001-RD]

Tamiya M06 Aluminum Rear Hub Carrier (Red)

Price:

CAD$12.41

Brand:

JAZRIDER

Model:

M06-13001-RD

Not Available

Please kindly input your name and email address, we will inform you once we have the restocking.

Or you may find similar product under the

Spares / Hop-ups - Tamiya - M06

Aluminum rear hub carrier for M06 upgrade

This red anodized aluminum rear hub carrier is a direct replacement made for the TAMIYA M06 chassis. As a machined alloy component it acts as the mounting point for the rear wheel assembly and connects to the rear suspension, offering a firmer seating surface than standard plastic parts.

Intended for setup and tuning, swapping to this carrier can reduce wheel mounting play and help preserve camber and toe settings under load, which supports more consistent handling through corners and traction changes. The red finish also makes the upgrade easy to spot during adjustments and setup checks.

Installation follows standard M06 rear-end disassembly. The carrier is designed to match the factory mounting points on the M06 rear upright and typically reuses the original fasteners and wheel hardware. Inspect mating surfaces and torque hardware to the chassis maker's recommended specifications when reassembling.

What tools and steps are required to fit this to an M06?

Remove the rear wheel and upright per the M06 service routine, unbolt the stock carrier, fit the alloy carrier to the same mounting points, and reuse the original fasteners where they seat correctly. Check alignment before final torquing.

Does the anodized red finish need special care during cleaning?

The anodize is cosmetic; clean with mild soap and water and avoid abrasive pads or harsh chemicals that could dull the surface. Light polishing is fine if needed.