Tamiya M06 Front Knuckle Arm Upgrade - M06-13000-LB by JAZRIDER  [M06-13000-LB]

Light blue anodized knuckle arms

This set of aluminum front knuckle arms is made for RC use on the Tamiya M06 chassis. They replace the stock plastic knuckles to provide a firmer mounting point for the steering linkage and deliver a steadier steering geometry under load.

Machined from light blue anodized aluminum, the components emphasize dimensional stability while retaining the original geometry. They act as a direct hop-up for M06 steering assemblies where a metal replacement is preferred for repeatable handling during setup and tuning.

When installing these knuckles, transfer bearings and hardware from the original parts and confirm ball stud alignment and steering arm clearance. After fitment, verify steering throw and camber settings remain in your desired range and check mating fasteners for correct engagement to avoid thread damage.

Maintenance is primarily visual inspection of bearing seats and fastener torque. The anodized surface adds corrosion resistance, but inspect contact areas after hard running or frequent adjustments for wear.