This rear shock tower is a purpose-made RC replacement part designed for the TAMIYA M06 chassis. Machined from aluminum, the component gives a firmer mounting point for the rear suspension than common plastic towers, helping maintain alignment under load and during tuning work.
Fitment and role: the tower locates the rear shock tops and acts as an anchor for suspension geometry adjustments. On track or at club runs, a rigid tower reduces flex at the shock mounts, yielding more consistent damping and easier comparison when you swap oil, springs, or mounting options.
Installation notes: the part replaces the stock rear shock tower on the TAMIYA M06 and uses the existing chassis mounting points. Inspect mating screw threads and use the original hardware where appropriate, tightening in stages to avoid stripping plastic bosses. The unit is supplied in a light blue finish that matches common M06 styling.
Practical tuning tips: after fitting an aluminum tower re-check static camber and toe under preload because the reduced flex can alter measurements slightly; make small incremental adjustments during setup runs to judge handling changes.
Copyright © 2008-2026 rcjaz.ca All rights reserved
