TAMIYA M06 Aluminum C Hub Upgrade - M06-13002-LB by Jazrider  [M06-13002-LB]

Overview of the M06 Aluminum C Hub

This JAZRIDER M06-13002-LB C hub is a direct-fit replacement for the TAMIYA M06 chassis, finished in light blue anodize. It swaps the factory plastic C hub for an aluminum unit to deliver firmer steering feedback and a more consistent pivot under load, useful when dialing front-end response on 1/10 touring cars.

Fitting is straightforward for anyone used to M06 front suspension work: remove the stock C hub and carrier, transfer any required pins or inserts, then secure the aluminum hub with the original hardware. After installation, check hex screw torque and confirm free rotation of the wheel hub and steering knuckle; small toe or camber tweaks are often needed after fitting.

As an aftermarket upgrade the C hub increases steering stiffness and alignment repeatability without changing ride height or basic suspension geometry. Use it within a measured tuning routine: install quality bearings, verify steering link geometry, and adjust toe or camber to balance handling. The light blue finish also makes the upgraded part easy to spot during setup and maintenance.