These Jazrider JR-M502-GU aluminum rear suspension arms are an RC-scale replacement part intended for Tamiya M05, M06 and MF-01X chassis. Designed as a direct-fit hop-up, the gun metal finish identifies the alloy surface treatment while preserving standard mounting locations used on the stock components.
In practical terms the arms serve two roles: provide a stiffer rear link to help keep suspension geometry consistent under load, and offer greater resistance to wear compared with typical plastic arms. They are neutral tuning components suitable for track tuning, practice sessions, or when replacing worn original parts.
Installation notes: install using the chassis’ existing pivot pins and hardware where possible, check alignment and clearances after fitting, and confirm ball-end and hinge-pin fit before running. No changes to servo, ESC, motor, or gearbox are required for mechanical fitment, as these arms interface only with the rear suspension assembly.
Tuning guidance: use these arms to fine-tune rear roll stiffness and toe stability by combining them with standard shock settings and swaybar adjustments; small changes in arm stiffness can influence traction and steering balance at the rear axle.
Compatibility: Compatible with Tamiya M05, M06 and MF-01X chassis rear suspension assemblies when using standard mounting geometry.
Copyright © 2008-2026 rcjaz.ca All rights reserved
