Tamiya M05 Graphite Steering Plate M05-25/WO by 3Racing  [M05-25/WO]

Graphite steering upgrade for M05

This graphite steering plate is an RC hop-up built for the Tamiya M05 chassis and supplied as model M05-25/WO. The graphite construction replaces the stock steering plate to increase stiffness at the steering mount and give a firmer, more predictable control feel for setup and on-track sessions.

Fitment is for M05 variants using the standard M05 steering geometry. Installation requires removing the factory plate, transferring linkage and fasteners to the graphite item, then checking steering neutral and alignment. This part is intended as a chassis tuning component within 1/10 on-road workflows.

In tuning terms the plate shifts steering load paths through the mount, so you should recheck toe and Ackermann after fitting to regain the handling balance you prefer. Use this as an incremental setup and maintenance part rather than something that changes electronics or the servo/ESC interface.