Tamiya M03/M03L/M04M/M06 Rear Hub Carrier Aluminium 2 Degree M04M-03/2/LB by 3Racing  [M04M-03/2/LB]

Aluminium rear hub carrier for Tamiya M03 family

This aluminium rear hub carrier from 3Racing is built to fit Tamiya M03, M03L, M04M and M06 PRO chassis and offers a fixed 2 degree option to tweak rear geometry. The component replaces the stock hub carrier on the listed vehicles while using the original mounting interfaces so other suspension parts remain unchanged.

Finish and material prioritise durability and consistent fit. The light blue anodised aluminium provides higher stiffness than standard plastic carriers while retaining the factory attachment points for straightforward swapping. The 2 degree offset is intended as a minor tuning change to alter rear behaviour in small steps.

Installation notes: confirm this part matches your chassis variant, remove the original rear hub carrier and refit using the vehicle's existing hardware where possible, check clearances at the rear upright and wheel hex before final torque, and verify wheel alignment after installation.

Chassis compatibility

• Tamiya M03
• Tamiya M03L
• Tamiya M04M
• Tamiya M06 PRO