Tamiya Hotshot Stabilizer Stay Upgrade - Aluminum, JR-THS03-RD by Jazrider  [JR-THS03-RD]

Sold as a pair of two, these red anodized aluminum stabilizer stays are made for Tamiya Hotshot and Hotshot II/2 RC buggies. They replace the factory plastic pieces to give a firmer attachment for stabilizer links and help make roll response and body lean behavior more repeatable through corners.

This is a tuning part aimed at chassis setup rather than a drivetrain change. Swapping the plastic stays for aluminum alters the stiffness around the stabilizer mount, which changes how the suspension and anti-roll link interact under load. Use them when testing front or rear roll balance or when adjusting shock damping and anti-roll settings.

Fitting is simple and the kit includes 2 pcs. Basic hand tools such as a hex driver and pliers are sufficient. Inspect existing screws and small spacers for wear, reuse compatible mounting hardware where possible, and recheck link geometry after installation to preserve correct ride height and steering behavior.