TAMIYA Hotshot Rear Drive Shaft & Wheel Axle Set - JR-THS17-BK by Jazrider  [JR-THS17-BK]

Jazrider Hotshot, Hotshot II, Super Hotshot, Bigwig Rear Drive Shaft w/Wheel Axle Set
Price:
CAD$11.10
Brand:
JAZRIDER
Model:
JR-THS17-BK
Condition:
Brand New
Available in shop
Write a review

Rear axle replacement for Hotshot series

This RC rear drive shaft and wheel axle kit fits TAMIYA Hotshot chassis variants and is intended to restore rear drivetrain performance after wear or impact, while providing a simple swap for rear-end geometry tuning on classic Hotshot layouts.

Installation focuses at the rear gearbox and wheel hub interfaces, using the stock mounting points on Hotshot series chassis. You will typically remove the rear hub assembly and axle carrier to replace the drive shaft, then reassemble using the original fasteners. No extra fabrication is necessary when used with the listed Hotshot models.

Tuning note: the set is a direct-replacement style item that helps correct axle alignment or adjust axle endplay during setup changes. After fitting, check axle engagement, hub clearance and the mesh between motor, spur and pinion to confirm they are within chassis tolerances.

Compatibility

  • Hotshot
  • Hotshot II
  • Super Hotshot
  • Bigwig

Will this fit standard Hotshot kits without modification?

Yes. It is made to match Hotshot series mounting points and installs using the existing hub hardware and axle carriers supplied with those kits.

Do I need to change other drivetrain parts when installing?

No other parts are normally required, though it is good practice to inspect the spur, pinion and motor alignment and replace any worn fasteners during reassembly.

What should I check after fitting the new axle set?

Confirm axle straightness, hub clearance and gear mesh before running the vehicle. Tighten hardware to spec and verify free rotation of the wheels.

Copyright © 2008-2026 rcjaz.ca All rights reserved