This RC stabilizer stay set is made for TAMIYA Hotshot and Hotshot II/2 chassis and is supplied as a pair of two pieces in a gun metal finish. Constructed from aluminum, the stays replace standard plastic components to influence chassis roll and tuning response.
Fitment uses the Hotshot mounting points and the vehicle's existing hardware. The aluminum offers a firmer mounting surface than common plastic stays, giving more consistent behaviour during suspension travel and cornering. After installation, check alignment, fastener torque, and clearance with adjacent suspension parts.
Tuning tip: changing to aluminum stays will affect front or rear roll balance depending on which stays are swapped, so make gradual adjustments and test between changes. This component is intended for RC chassis tuning and maintenance only, not for full-size vehicles.
Copyright © 2008-2026 rcjaz.ca All rights reserved
