TAMIYA HOTSHOT II 7075 Alloy Wheel Hex Set HS2010 by GPM  [HS2010]

7075 Alloy Wheel Hexes for HOTSHOT II

This aftermarket set of wheel hexes is made for the TAMIYA HOTSHOT II platform and supplied under model HS2010. Designed as an RC-scale replacement, these hexes use 7075 aluminum to balance strength and low weight for hobby runs and setup work.

These hexes form the wheel mounting interface on the 1/10 HOTSHOT II, allowing you to replace worn stock parts to recover concentricity and correct wheel alignment. The 7075 material helps resist deformation under common RC loads while keeping rotational mass down for crisper steering response.

For fitment, check each hex against the HOTSHOT II hubs and reuse the existing wheel fastening hardware from your model. They are intended for RC-scale use only and should be inspected for correct seating before each run.

Fit these 7075 hexes to replace damaged wheel interfaces on the HOTSHOT II and maintain repeatable wheel mounting for tuning and consistent handling.