TAMIYA Hotshot Series Gear Box Stay with Stabilizer Mount for chassis tuning - JR-THS08-LB by Jazrider  [JR-THS08-LB]

Tamiya Hotshot, Super Hotshot, Hotshot II Aluminum Gear Box Stay w/Stabilizer Mount Set (Blue)
Price:
CAD$11.60
Brand:
JAZRIDER
Model:
JR-THS08-LB
Condition:
Brand New
Available in shop
Write a review

Aluminium Gear Box Stay with Stabilizer Mount

This aluminium gear box stay with stabilizer mount is a scaled RC accessory built to fit the TAMIYA Hotshot family of chassis. It arrives in blue and provides a firm mounting point for the gearbox and a bracketed location for a stabilizer on the model.

The component is intended to stabilise the gearbox area and give a repeatable anchor for a stabilizer, helping preserve gearbox alignment during setup and use. Fitment supports routine chassis tuning where gearbox position and stabilizer attachment are factors.

Compatibility notes are listed below; verify fit on your specific chassis before installing. The item is supplied as an aftermarket accessory for hobby RC models.

Compatibility

  • Hotshot — Front and Rear Gear Box
  • Super Hotshot — Front and Rear Gear Box
  • Hotshot II — Front Gear Box only

How do I install this gear box stay on a Hotshot?

Installation normally replaces the stock stay or mounts alongside existing gearbox hardware; follow the vehicle assembly points and check that the stabilizer aligns with your chassis posts before final tightening.

Will I need extra screws or spacers?

The listing does not guarantee included fasteners; inspect photos or contact the seller to confirm whether mounting bolts and spacers are supplied for your Hotshot variant.

Is the blue finish prone to corrosion?

The part is machined from aluminum and anodised blue; normal hobby use resists corrosion but avoid prolonged salt exposure and wipe down after wet runs to preserve the finish.

Copyright © 2008-2026 rcjaz.ca All rights reserved