TAMIYA Hornet EVO Aluminum Rear Lower Arms (Red) - JR-THNE02-RD by Jazrider  [JR-THNE02-RD]

Aluminum rear lower arms for Hornet EVO

This RC-scale replacement rear lower arm set is made for the TAMIYA Hornet EVO (58742) chassis and comes finished in red aluminum by Jazrider. These components are intended as direct-fit replacements for the stock rear lower arms and are suitable for maintenance, repair, and basic suspension setup tasks.

Material and fit: the arms use aluminum construction with a red finish and match the factory mounting points on the Hornet EVO (58742). They preserve the original mounting geometry while providing a metal alternative to the OEM plastic arms. Check pivot and hub pin alignment during fitting to maintain correct suspension travel.

Installation notes: standard RC tools such as a hex driver and pliers will handle removal of the stock arms and installation of these aluminum parts. Reuse existing screws and hardware where possible; if replacements are required, use compatible fasteners. Tighten fasteners securely but avoid over-torquing to prevent thread damage in plastic hubs or bulkheads.

Tuning role: these rear lower arms are an adjustment and maintenance item rather than an electronic upgrade. They stabilise rear suspension geometry for repeatable toe and camber settings and simplify part swaps during trackside or field maintenance. Inspect ball cup seating and pivot wear regularly as part of routine checks.