Tamiya GT-01 Titanium Screw Set - TS-GT01/V1 by 3Racing  [TS-GT01/V1]

Tamiya GT-01 GT01 Titanium Screw Set - 3RACING TS-GT01/V1
Price:
CAD$45.14
Brand:
3Racing
Model:
TS-GT01/V1
Condition:
Brand New
Write a review

Lightweight titanium fasteners for Tamiya GT-01

This titanium screw set is supplied as a dedicated hardware pack for the Tamiya GT-01 chassis. The fasteners use titanium to reduce mass and resist corrosion compared with standard steel hardware, making them useful for builders seeking careful weight control and long-term reliability.

Installation is simple for anyone familiar with small-scale RC assembly: replace factory steel screws where thread size and head type match, trial-fit every piece before final torque, and tighten cautiously to avoid stressing plastic or aluminium parts. These screws are especially useful for body mounts, shock towers and suspension link points where weight savings and corrosion resistance are priorities.

Specifications

  • Item: Titanium screw set
  • Material: Titanium
  • Model Number: TS-GT01/V1
  • Compatibility: Tamiya GT-01 (GT01) chassis

Fit notes

  • Tamiya GT-01 (GT01)

Use these titanium fasteners where reduced weight and corrosion protection are desired, and always verify thread fit and head type before final installation to preserve reliable assembly on your GT-01 model.

How should I verify each screw before fitting?

Compare each titanium screw to the corresponding stock fastener, checking thread pitch and head profile. Hand-start every screw to confirm fit before applying final torque.

Can I use threadlocker with these titanium screws?

A small amount of low-strength threadlocker is acceptable on metal-to-metal joints; avoid using permanent threadlock on parts that press into soft plastic. Apply sparingly and follow the threadlocker manufacturer guidance.

Are titanium screws safe for suspension and shock mounts?

Titanium offers good corrosion resistance and reduced weight, but note that clamping characteristics differ from steel. Use correct torque and inspect mating surfaces to avoid loosening or deformation.

Do I need special tools to fit these screws?

Standard precision drivers or hex bits sized to the screw heads are sufficient. Use a correctly sized bit to minimise cam-out and protect the screw head.

Copyright © 2008-2026 rcjaz.ca All rights reserved