Tamiya GB-01/GB-01T/GT-01 0 Degree Aluminum Rear Hub - GB-04/0/LB by 3Racing  [GB-04/0/LB]

Lightweight aluminum rear hub for GB-01 platforms

This aluminum rear hub is designed for RC use with Tamiya GB-01, GB-01T and GT-01 chassis. The part comes in a light blue finish and is supplied in a 0 degree orientation, offering a metal alternative to the stock plastic hubs for improved longevity at the rear mounting points.

Fit and role: made to align with the rear hub mounting points on the listed Tamiya chassis, this hub locates wheel retention hardware and suspension link attachments. The 0 degree orientation means it preserves neutral rear hub geometry when installed, useful for setups that require no offset.

Installation notes: replace the hub following standard GB-01 family procedures, using the correct fasteners and confirming alignment after assembly. Check nearby fasteners and bearings during the swap and verify wheel clearance and suspension travel once fitted.

Tuning guidance: hobbyists fit an aluminum rear hub like this to keep consistent pivot points while testing rear geometry, to stabilise setup changes, or to add a clean metal finish to the rear axle area.