Tamiya FF-03 Graphite Servo Protector FF03-21/WO by 3Racing  [FF03-21/WO]

FF-03 servo bay graphite shield

This RC-scale graphite servo protector is made for the Tamiya FF-03 chassis family and carries part number FF03-21/WO. The lightweight, stiff panel shields the servo mounting area from impacts and adds targeted chassis rigidity without changing suspension geometry.

Intended specifically for FF-03 layouts, the hop-up suits 1/10 electric touring cars and should be used as a reinforcement panel rather than a primary structural element.

Fitting is simple: position the protector over the servo pocket and fasten to the existing FF-03 mounting points using the stock hardware or standard hex drivers. Verify servo lead and receiver clearances before final tightening to avoid pinch points.

In setup work the protector helps keep servo housings out of direct contact in minor incidents and reduces local flex around the servo bay, which can stabilise steering feel when combined with sway bar and damper adjustments and proper servo saver setup. It fits common aftermarket servos but confirm overall servo dimensions before installation.