Tamiya FF02 Rear Lower Suspension Arms Machined Aluminium FF02-01/LB by 3Racing  [FF02-01/LB]

Machined Aluminium Rear Lower Arms for FF02

This machined aluminium rear lower suspension arm set is made for the Tamiya FF02 chassis as an aftermarket hop-up to replace the standard plastic lower rear arms. The aluminium build increases wear resistance versus stock plastic while keeping attention on chassis feedback and longevity.

These arms form the pivot points for rear suspension links and wheel hubs. Fitting machined aluminium reduces flex at the lower pivot, helping to keep suspension geometry consistent through repeated runs and allowing finer rear-end tuning on track.

Installation uses the original FF02 mounting locations. Fit one side at a time to preserve alignment, check ball stud and hinge pin seating, and confirm free wheel hub rotation before final tightening. Recheck rear toe and camber as part of your setup verification.

Choose this part to replace worn plastic arms or to gain a more repeatable rear suspension feel during practice and club racing sessions.

Compatibility: Tamiya FF02 chassis