Tamiya F103/F104/RM01 1/4 Bearing Rear Axle Height Adapter - Factory Pro O-AP0008  [FP-O-AP0008]

Factory Pro FP-O-AP0008 1/4 Bearing Rear Axle Hight Adapter (for Tamiya F103, 104 & RM01 Series)
Price:
CAD$27.40
Brand:
Factory Pro
Model:
FP-O-AP0008
Condition:
Brand New
Write a review

Fine rear axle height tuning for F103 F104 RM01

This Factory Pro O-AP0008 accessory is an RC-scale rear axle height adapter built for use with Tamiya F103, F104 and RM01 on-road chassis. It locates at the 1/4 bearing seat to allow small, repeatable changes to rear axle height so you can dial in rear ride height and balance without swapping major suspension components.

Compatibility is limited to the Tamiya models listed; check the bearing seat dimensions on your specific chassis version before fitting. This item is intended for hobby and track tuning of electric on-road models only.

Installation is straightforward for those used to on-road maintenance: remove the rear axle supports, place the adapter onto the bearing seat to the desired position, then reassemble using the existing fasteners. Make only small adjustments and verify handling on a setup stand or during cautious test runs.

Specifications

  • Item 1/4 Bearing Rear Axle Height Adapter
  • Model Number O-AP0008
  • Compatibility Tamiya F103, 104 & RM01 Series

Use this adapter as a precise tuning tool to refine rear geometry and balance on compatible Tamiya on-road cars; test each change incrementally before finalising your setup.

How small of a height change can I make with this adapter?

The adapter provides incremental seating adjustments at the 1/4 bearing interface, allowing very small rear height changes suitable for tuning turn-in and rear traction.

Will this affect my existing drivetrain alignment?

Minor axle height changes can alter driveline angles slightly; check gear mesh and shaft alignment after fitting and run a slow test to confirm smooth operation.

Do I need special bearings to use the adapter?

No special bearings are required if your chassis already uses the 1/4 bearing interface; verify seat size and reuse the existing bearing where compatible.

Is the Factory Pro O-AP0008 sold as a single unit?

Product listings usually reference the single Factory Pro O-AP0008 adapter; check the vendor page for pack quantity and shipping details.

Copyright © 2008-2026 rcjaz.ca All rights reserved