Tamiya DT-03 Rear Aluminum Hub Carrier - JR-DT307-LB by Jazrider  [JR-DT307-LB]

DT-03 Rear Hub Carrier Overview

This aluminum rear hub carrier is an RC-scale replacement part designed for the Tamiya DT-03 chassis. Machined from aluminum and finished in light blue anodizing, it provides a direct-fit option intended to replace the standard rear hub carrier on DT-03 rear assemblies.

Functionally the part serves as the mounting point for the rear wheel hubs and influences wheel alignment and suspension geometry. Replacing the stock component with an aluminum carrier increases rigidity at the rear mount and reduces deformation under load, which helps when making precise adjustments to toe and camber during setup and track tuning.

Installation is straightforward for model technicians familiar with DT-03 maintenance: remove the rear wheel and hub assembly, detach the existing hub carrier, and fit this carrier using the same mounting points and hardware. After installation, verify wheel alignment and clearances before running the model.

Note: this is a scale RC part intended only for Tamiya DT-03 chassis use; check fitment on your model before final installation and ensure compatibility with your wheel hex and axle setup.