Tamiya DT-03 Aluminum Rear Hub Carrier JR-DT307-OR by Jazrider  [JR-DT307-OR]

DT-03 rear hub carrier summary

This aluminum rear hub carrier is an RC-scale replacement designed specifically for the Tamiya DT-03 chassis. It replaces the stock rear hub carrier to provide a machined aluminum mounting point for the rear wheel hub, maintaining the familiar DT-03 installation geometry while adding the dimensional stability of metal construction.

Installation is straightforward for anyone familiar with DT-03 maintenance: remove the original hub carrier, transfer any bearings or small hardware as required, install the replacement using the existing mounting points and hardware, and verify wheel alignment and suspension travel. Basic tools such as a hex driver and a wrench for the axle nut are typically all that is needed.

From a tuning perspective the part acts as a rigid mounting base for the rear suspension and steering linkages, helping alignment hold under load and offering a consistent pivot surface for setup changes. The orange anodized finish helps visual checks during rebuilds and the standard fastener pattern preserves compatibility with DT-03 replacement workflows.