This RC-scale accessory is a replacement rear hub carrier designed for the Tamiya DT-03 chassis, offered as model JR-DT307-BK. Machined from aluminum, the carrier provides a metal mounting point for the rear suspension and wheel spindle areas as a direct spare or hop-up option.
Use is straightforward: remove the rear wheel and any brake or drive components needed to access the hub carrier, then swap the stock part for the aluminum unit. The metal carrier is intended to support routine maintenance and chassis setup adjustments where a firmer mounting surface is preferred over the original plastic piece.
Installation notes: keep original screws and spacers unless the replacement kit specifies otherwise, inspect fasteners for wear, and verify wheel alignment and bearing seating after fitting. Use standard hand tools and confirm the rear suspension moves freely with no binding following installation. This description addresses the part as an RC replacement component, not a full-size vehicle item.
Handling and tuning: replacing the plastic hub carrier with an aluminum unit increases pivot stiffness at the rear, which can help the car maintain geometry under load and deliver a more consistent response when changing toe or camber settings; final results depend on the full suspension setup.
Copyright © 2008-2026 rcjaz.ca All rights reserved
