This JR-DT307-RD aluminum rear hub carrier is an RC-scale replacement part designed for use with the Tamiya DT-03 chassis. The component is finished in red and uses an aluminum construction to deliver greater rigidity than typical stock plastic carriers.
Intended role and tuning notes: positioned at the rear hub, the carrier reduces flex under load and promotes a more consistent suspension response. When a firmer rear-end feel is required, it helps provide predictable handling changes during trim and shock adjustments.
Installation guidance: remove the rear wheel and original hub carrier following chassis service steps, transfer any bearings or pins from the stock part, then install this aluminum carrier using the original fasteners and a correct hex driver. Verify wheel alignment and suspension travel after installation and recheck fastener torque during initial runs.
Notes on compatibility and scope: the product name specifies DT-03 compatibility; do not assume fitment on other Tamiya platforms without verification. This item is an RC accessory and is not intended for full-size vehicle use.
Copyright © 2008-2026 rcjaz.ca All rights reserved
