This RC-scale aluminum C hub fits TAMIYA DT-03 chassis assemblies and replaces the factory plastic C hub in the front steering knuckle area. The unit is finished in anodized green and is intended as a direct metal alternative to the original part.
Compatibility is specific to DT-03 based setups. Typical installation requires removing the stock C hub from the steering knuckle, fitting the aluminum hub using the existing hardware, and confirming orientation and clearance before final tightening. Because this is metal, check for any contact with surrounding suspension or steering parts after installation.
From a tuning perspective, an aluminum C hub gives a firmer steering knuckle mount that can alter steering feedback and suspension response. When you swap to an aluminum hub, inspect wheel hexes, steering linkages, and bearings to keep geometry consistent and prevent binding.
Copyright © 2008-2026 rcjaz.ca All rights reserved
