Tamiya DT02/DT03/TT02B Rear Alloy Steel #45 CVD Drive Shafts DT3264SC by GPM  [DT3264SC]

Rear CVD replacement for Tamiya DT platforms

This rear constant velocity drive shaft is a direct replacement designed for Tamiya DT02, DT03 and TT02B chassis. The driven half-shafts are made from alloy steel #45 and the item is supplied as 1 pr to swap into the rear drivetrain when original parts wear out.

Fitment targets the listed chassis; this unit does NOT fit Tamiya 58374. It is produced for hobby use to restore drivetrain geometry, reduce play at the rear diff output, and provide a durable upgrade over worn plastic or lower-grade metal drives.

Installation follows typical rear CVD swap routine: remove rear hubs and driveline parts to access the shaft ends, confirm set-screw and hex seating, and check axle alignment through suspension droop to avoid binding. Minor set-screw trimming or a dab of low-strength thread-lock on steel fasteners may be used during reassembly as needed.

Match replacement shafts to the chassis code to ensure correct spline count and length, and inspect related bearings and hub hardware while performing the swap.