TAMIYA DF01 Steering Linkage Replacement DF1048 by GPM  [DF1048]

Replacement steering for DF01

This aftermarket steering assembly is produced for the TAMIYA DF01 platform and supplied as a single replacement set that includes bearings. It is an RC-scale part intended to restore or fine-tune steering linkage geometry on DF01 chassis and does not imply any real vehicle use.

The unit replaces worn steering components and fits bearings at the pivot points to cut play and improve repeatable steering input under load. Carry out basic trim checks and confirm servo horn alignment when installing to preserve intended toe and Ackermann behaviour.

Fitting uses standard DF01 steering hardware and routine setup: remove the original steering block, transfer any reusable linkages, locate the assembly on the steering knuckles, and secure with the factory fasteners while checking steering centring and free travel.

For DF01 owners wanting a straightforward drop-in steering replacement with built-in bearings, the DF1048 set addresses wear and can sharpen steering feel while keeping stock geometry for tuning.