TAMIYA CW-01 Aluminum Front Arm Bulk for The Hornet and Grasshopper - JR-LB05-RD by Jazrider  [JR-LB05-RD]

Tamiya CW-01 / The Hornet / Grasshopper Aluminum Front Arm Bulk (Red)
Price:
CAD$9.56
Brand:
JAZRIDER
Model:
JR-LB05-RD
Condition:
Brand New
Available in shop
Write a review

Billet Front Arm Bulk - Red Anodized

This aluminum front arm bulk is an RC-scale replacement part designed for use with the TAMIYA platforms named in the product title. It provides a metal alternative to the stock plastic component and is finished in red anodized alloy for a tuned appearance and improved wear resistance.

Compatibility is limited to the models named: CW-01, The Hornet, and Grasshopper. The component is supplied as a front arm bulk intended for installation into the vehicle's front arm assembly on those specific TAMIYA CW-01 platforms.

Consider this part a structural upgrade that will change steering behavior and front-end stiffness. After fitting, inspect steering alignment and make small incremental adjustments to toe and caster to re-establish the handling balance you prefer.

Which TAMIYA CW-01 models will JR-LB05-RD fit?

The JR-LB05-RD is designed to fit TAMIYA CW-01 variants specifically listed in the title: The Hornet and Grasshopper. Always double-check fit against your chassis before final installation.

Is this meant to replace the stock plastic front arm bulk?

Yes. This aluminum front arm bulk is supplied as a direct replacement for the original front arm bulk on the named CW-01 models and increases front-end rigidity.

What setup checks should I perform after installing the aluminium bulk?

Verify steering alignment and front-end feel, then adjust toe and caster gradually until the vehicle returns to your desired handling characteristics.

Copyright © 2008-2026 rcjaz.ca All rights reserved