TAMIYA CC-02 Rear Cross Brace Installation Upgrade - JR-CC202-LB by JAZRIDER  [JR-CC202-LB]

Installation and Fit for CC-02

This aluminum rear cross brace is made for the Tamiya CC-02 scale chassis as a direct replacement or upgrade to reduce rear flex and improve trail handling. Machined from anodized aluminum in a blue finish, the component increases rear-end stiffness to influence handling balance while leaving suspension geometry unchanged.

Fitting is straightforward on CC-02 layouts that retain the stock rear mounting points; the brace fastens to existing attachment locations and works with the vehicle's original brackets. During install, confirm alignment and use even fastener torque to prevent preload or misalignment across the rear section.

For trail and crawler setups this brace helps cut rear chassis torsion, yielding crisper throttle response and reducing the need for constant steering correction at low speeds. It is intended as an RC-scale tuning element to adjust chassis rigidity rather than a substitute for suspension tuning.

• Compatibility: Designed for Tamiya CC-02 chassis layouts.
• Role: Rear chassis stiffening to affect handling balance in crawling and trail runs.
• Maintenance tip: Check mounting points after initial runs and re-tighten as needed.