Tamiya CC-02 Front/Rear Aluminum Shock Tower Upgrade JR-CC203-RD by Jazrider  [JR-CC203-RD]

Red anodized shock tower for CC-02

This aluminum front and rear shock tower is a scale replacement crafted for use on Tamiya CC-02 chassis layouts. Machined from aluminum and finished in red anodize, the piece replaces the factory plastic towers to give a firmer mounting point for shocks and to help stabilize suspension geometry during heavier tuning or when fitting upgraded shock assemblies.

Fit this tower when you require a rigid top mounting for setup work or when installing aftermarket shocks that need tighter tolerances at the mounting eyes. The tower's role is mechanical: it sets the shock top positions, affects leverage and roll behavior, and provides repeatable mounting points for suspension adjustment procedures.

Installation notes: keep the original mounting hardware where practical, verify alignment before final torque, and recheck shock lengths and preload after fitment to restore intended ride height and travel. This item is sold as an RC accessory part and does not include extra hardware unless the seller states otherwise.