Tamiya CC-02 Aluminum Front Knuckle Arms JR-CC200-LB — Anodized Blue by Jazrider  [JR-CC200-LB]

Front Knuckle Arms — Tamiya CC-02 Upgrade

These aluminum front knuckle arms are an RC-scale steering upgrade made for the Tamiya CC-02 chassis, finished in anodized blue to resist surface wear and to provide consistent wheel mounting contact points. The component replaces the stock plastic knuckles to cut down play under load and help keep steering geometry stable during setup and demanding practice sessions.

Fitment follows the CC-02 layout exactly, using the same pivot and ball-stud locations as the original knuckles so existing steering linkages and wheel hexes remain compatible. This part is intended for hobby-grade remote-controlled models and should be handled and installed with the correct RC tools for small fasteners and alignment checks.

Installation notes: remove the front hub assembly, transfer bearings or wheel hexes from the stock knuckles, fit the aluminum knuckles onto the steering posts, and reassemble while checking steering throw and toe settings. After installation, confirm there is no binding through the suspension travel and verify the servo centres before a test run.