Tamiya CC-01 Spring Steel Servo Tie Rod - CC16247ST by GPM  [CC16247ST]

Tamiya CC01 Spring Steel Servo Tie Rod - 1pc set - GPM CC16247ST
Price:
CAD$4.83
Brand:
GPM
Model:
CC16247ST
GTIN:
4894538032291
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Steering link improvement for CC-01

This single-piece spring steel tie rod is built for Tamiya CC-01 chassis setups and replaces softer factory links to cut steering flex and give crisper feedback between the servo horn and steering knuckle.

Installation is simple: remove the original tie rod from the servo horn and steering arm, screw this unit into the existing ball cup or rod end, then check thread engagement and free movement through the steering arc. Trim or relocate any interfering sway components to avoid binding at full lock, and re-check for end play after a short test drive.

For tuning, a spring steel link controls unwanted compliance while avoiding excessive overall stiffness. Use it to fine tune steering return and slow-speed precision; it is not intended as a structural substitute for major suspension upgrades.

This item is compatible with

  • TAMIYA CC01

Is this a direct fit for CC-01 knuckles?

It is designed to work with standard CC-01 steering rod ends and ball cups; in most builds it installs without modification.

How do I avoid binding at full lock?

Confirm correct thread depth, check linkage geometry through the full steering sweep, and trim nearby links or relocate swaybar mounts if needed to prevent contact at extreme angles.

Will this change steering feel dramatically?

Expect firmer feedback and reduced compliance, especially at low speed; it sharpens steering return without making the whole assembly overly stiff.

Copyright © 2008-2026 rcjaz.ca All rights reserved