This centre drive shaft is a scale replacement designed for TAMIYA CC-01 platforms, targeted at Volkswagen Amarok builds on a 267mm wheelbase. The unit combines steel and aluminium to balance strength and mass while allowing a 138mm to 145mm adjustment to close small chassis spacing gaps.
The aluminium body is suitable for anodizing to add colour, while the steel sections take the wear where torque is transmitted. The compact layout preserves the original gearbox geometry and focuses on dependable drivetrain performance.
Installation is straightforward for those familiar with CC-01 layouts: the shaft replaces the stock centre drive and pairs with existing original components. No specialist tooling beyond common hex drivers is required; confirm spline engagement and shaft alignment during trial fitting to avoid binding.
Use this shaft to replace worn centre drives or to gain a small amount of length adjustment for CC-01 Amarok setups; verify fit before final assembly and keep threads and splines lightly greased for longer service life.
Copyright © 2008-2026 rcjaz.ca All rights reserved
