Tamiya Blitzer Beetle Rear Aluminum Suspension Arms - JR-TASB02-BK by Jazrider [JR-TASB02-BK]

Aluminum Rear Suspension Arms (Black) For Blitzer Beetle / Stadium Blitzer / Stadium Thunder

Price:

CAD$19.81

Brand:

JAZRIDER

Model:

JR-TASB02-BK

Condition:

Brand New

Quantity:

Available in shop

Write a review

Description
FAQ

Billet rear suspension arms for the Blitzer line

This RC-scale aluminum rear suspension arm set replaces the stock plastic arms on the Tamiya Blitzer Beetle, Stadium Blitzer and Stadium Thunder chassis. Machined aluminum with a black finish provides a firmer mounting point for the rear suspension compared with the original plastic components.

The parts are designed to mate with the factory rear arm mounts and preserve original suspension geometry. Installing these arms reduces mounting-point flex, which helps maintain wheel alignment under load and supports more predictable handling while tuning.

Installation follows standard rear-arm replacement procedures used on these Tamiya chassis. After fitment, check wheel alignment and suspension travel and recheck fastener torque after the first run. This item is an RC-scale accessory intended for model car use only.

How can I confirm these arms fit my Tamiya model?

They are built for the Tamiya Blitzer Beetle, Stadium Blitzer and Stadium Thunder platforms; confirm your car uses the same rear arm mounts as those models before ordering.

Will switching to aluminum affect handling?

Aluminum arms reduce flex at the mounting points and generally yield a firmer rear-end response, which can make handling more consistent when adjusting suspension settings.