TAMIYA BBX BB-01 Rear Pull Rod Bracket 7075-T6 BBX030 by GPM  [BBX030]

7075-T6 rear pull rod bracket

This aftermarket bracket is an RC-scale replacement engineered to secure the rear swing arm pull rod on TAMIYA BBX BB-01 chassis. Machined from 7075-T6 aluminum, it clamps and stabilizes the pull rod so rear suspension geometry stays correct during setup and inspection. The package contains the bracket and the screws listed below for a direct swap with the stock bracket on specified BBX BB-01 chassis.

Designed for hobby use on 1/10 scale BBX BB-01 models, the part does not change the suspension concept but provides a reliable mounting point for the pull rod. Fitment is achieved using the supplied hardware and the existing mounting points on the chassis listed in the compatibility section.

Use this bracket to replace the stock rear pull rod mount on the BBX BB-01, restoring a fixed mounting point so rear linkage geometry remains repeatable for setup and troubleshooting.