TAMIYA BB-01 (BBX) Front Lower Suspension Arm Mount Upgrade - JR-TBB03-GU by Jazrider [JR-TBB03-GU]

Tamiya BB-01 (BBX) Aluminum Front Lower Suspenison Arm Mount (Gun Metal)

Price:

CAD$13.91

Brand:

JAZRIDER

Model:

JR-TBB03-GU

Condition:

Brand New

Quantity:

Available in shop

Write a review

Description
FAQ

Aluminum Front Lower Mount Details

This is an RC-scale front lower suspension arm mount made for the TAMIYA BB-01 (BBX) chassis, supplied as model JR-TBB03-GU. The component is machined from aluminum with a gunmetal finish to replace the stock plastic piece where greater rigidity and consistent mounting geometry are required for precise model setup and maintenance.

The mount is designed to act as a direct replacement for the front lower arm mounting point on BB-01 (BBX) layouts. Installation normally uses the existing chassis mounting holes and original fasteners, preserving the factory suspension geometry. Verify alignment and torque during fitting to maintain correct steering response and suspension behavior.

For tuning and repairs this aluminum mount stabilizes the lower arm pivot, reduces flex under load, and gives repeatable fitment when swapping arms or adjusting setup. It is intended solely for scale RC suspension systems and not for use on real vehicles.

Will this mount fit the BB-01 (BBX) without chassis modification?

Yes. It is manufactured to match the BB-01 (BBX) front lower arm mounting points so no chassis trimming is normally required.

Do I need special hardware to install this part?

In most cases you can reuse the chassis screws. A small hex driver is typically all that is needed to remove the old mount and fit the new aluminum unit.