Tamiya BB-01 (BBX) Aluminum Steering Assembly, Red Anodized - JR-TBB02-RD by Jazrider  [JR-TBB02-RD]

Tamiya BB-01 (BBX) Aluminum Steering Assembly Set (Red)
Price:
CAD$14.50
Brand:
JAZRIDER
Model:
JR-TBB02-RD
Condition:
Brand New
Available in shop
Write a review

Machined aluminum steering for BB-01

This JR-TBB02-RD steering assembly is an aluminum replacement set designed for use on Tamiya BB-01 (BBX) scale models. It is presented as a direct-fit steering assembly intended to match the original BB-01 steering geometry while replacing the factory steering components with machined aluminum pieces.

The set's role is focused on steering control and tuning: using aluminum components can reduce flex compared with standard plastic parts, which helps maintain consistent steering angles during throttle changes and when adjusting throw or Ackermann settings. The red anodized finish identifies the upgrade visually without altering mounting points.

Installation notes: the assembly is intended to mount to the BB-01 steering points and to interface with the stock linkage layout. Installation follows the chassis' existing geometry so no chassis modification should be required, however confirm alignment and free movement through the full steering sweep before first run.

How do I verify this fits my BB-01 variant?

Check your chassis for the BB-01 steering mounting pattern and confirm the pickup points match the kit locations; if your chassis uses the BBX steering geometry this assembly is intended to bolt in place.

What material and finish are used on the parts?

Components are machined aluminum with a red anodized surface finish that resists wear and provides a uniform appearance compared with raw metal.

Will I need to alter the chassis to install this?

No chassis modification is expected; the parts are intended to use existing BB-01 mounting points. Always test steering range and check for binding after installation before running.

Copyright © 2008-2026 rcjaz.ca All rights reserved