Tamiya 92450 HG Carbon Multi Roller Setting Stay (3mm) for competitive Mini 4WD chassis  [92450]

Tamiya 92450 - HG Carbon Multi Roller Setting Stay (3mm/Silver) Waigo Hobby Limited
Price:
CAD$17.54
Brand:
Tamiya
Model:
92450
GTIN:
4950344924509
Condition:
Brand New
Available in shop
Write a review

Tamiya 92450 HG 3mm silver carbon stay — installation notes

This HG Carbon Multi Roller Setting Stay is a limited Waigo Hobby release that uses a single-piece 3mm silver carbon fiber plate. The thicker 3mm section increases structural stiffness compared with common 1.5mm sheets and is an alternative to stacked-plate assemblies, while the silver carbon finish and purple marking set this edition apart from standard black carbon tune-up parts.

For hands-on builders, the one-piece 3mm construction simplifies assembly compared with layered plates and reduces flex and local deformation at typical mounting points. The stay preserves conventional mounting hole placement so it can be integrated into most roller setups without extensive rework, though checking hardware length is recommended.

The run is presented as a limited commemorative item from Waigo Hobby. As with other tune-up components, confirm fitment on your selected Mini 4WD chassis before final installation and keep original parts available for events that require specific equipment compliance.

How does the 3mm thickness of the Tamiya 92450 HG stay change my installation steps?

The single-piece 3mm plate can require slightly longer mounting hardware at some roller stacks; verify screw and spacer lengths during a dry fit. Other than that, standard hole positions are kept to simplify replacement of stacked plates.

Is the silver carbon finish only visual or does it alter performance?

The silver surface is primarily an aesthetic treatment. Mechanical behavior is driven by the 3mm carbon construction; expect similar material properties to other carbon stays of comparable thickness.

Will I need to modify my roller mounts to fit this stay?

Most standard roller assemblies accept this part without major modification thanks to conventional hole placement. Still, perform a trial assembly and inspect clearances and spacer stack before final tightening.

Can this Tamiya 92450 HG stay be used in Stock Class events?

Event eligibility depends on the class regulations in force. The 3mm stay is a structural option; confirm rules for permitted parts before using it in any regulated Stock Class competition.

Does a single-piece 3mm plate resist impact better than layered 1.5mm plates?

A monolithic 3mm plate typically avoids bonded seams and can show improved edge and joint impact resistance versus layered 1.5mm stacks. Final performance still depends on mounting geometry and load points.

How is the limited Waigo Hobby edition identified?

This limited run is distinguished by its silver carbon finish and purple lettering specific to the Waigo Hobby commemorative release. Availability is limited, so check sellers for current stock.

Copyright © 2008-2026 rcjaz.ca All rights reserved